We are getting about 15 sqft finished per hour off of our titans. Is that what most people see? Mostly 3cm and we are using high speed tooling and a zoller. Sink cutouts done on the sawjet. Back grinding the seams.
SQFT per hour
- Thread starter Steven Mast
- Start date
We are getting about 15 sqft finished per hour off of our titans. Is that what most people see? Mostly 3cm and we are using high speed tooling and a zoller. Sink cutouts done on the sawjet. Back grinding the seams.
That is pretty much right around where we are. 15-25 sqft/hour depending on the edge finish. If I am running quartzite (taj mahal) with a bull nose, I run the slowest setting at about 10-15% of speed to avoid breakages.
If we do that, we do about 5-10 sq.ft/hour but that is still much better than reapairing breakages.
If we do that, we do about 5-10 sq.ft/hour but that is still much better than reapairing breakages.
